| Customization: | Available |
|---|---|
| Certification: | CE |
| Warranty: | 1 Year |
|
Still deciding? Get samples of US$ 1416/Piece
Order Sample
|
| Shipping Cost: | Contact the supplier about freight and estimated delivery time. |
|---|
| Payment Methods: |
|
|---|---|
| Support payments in USD |
| Secure payments: | Every payment you make on Made-in-China.com is protected by the platform. |
|---|
| Refund policy: | Claim a refund if your order doesn't ship, is missing, or arrives with product issues. |
|---|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
| Galin/Gema Three-pieces powder spray/painting/coating machine OPTF (Control unit CG07 + gun GM02+ 10L Hopper) |
 |
|
| GALIN POWDER COATING MACHINE (Control unit CG07 + gun GM02+ 10L Hopper) ELECTRICAL DATA |
|
| Nominal input voltage | 110V240VAC |
| Frequency | 50-60Hz |
| Connected load (without vibrator) | 140 VA |
| Nominal output voltage (to the gun) | eff.10 V |
| Nominal output current (to the gun) | max. 1.2 A |
| Connection and output for vibrator (on Aux output) | 110/230 VAC max. 100 W |
| Connection for rinsing function (valve) | 24 VDC max. 3 W |
| Temperature range | 0°C - +40°(+32°F - +104°F) |
| Max. surface temperature | 120 °C (+248 °F) |
| Approvals | II 3 D IP54 120 °C |
| GALIN POWDER COATING MACHINE (Control unit CG07 + gun GM02+ 10L Hopper) PNEUMATICAL DATA |
|
| MAX.input pressure | 10bar |
| MIN.input pressure | 6bar |
| Input pressure (Dynamic based on pressure regulator setting) |
5.5 bar / 80 psi |
| Max.water vapor content of the compressed air | 1.3g/Nm³ |
| Max.oil vapor content of the compressed air | 0.1mg/Nm³ |
| Max.compressed air consumption | 8Nm³/h |
| GALIN POWDER COATING MACHINE (Control unit CG07 + gun GM02+ 10L Hopper) PROCESSIBLE POWDER |
|
| Plastic Powder: | √ |
| Metallic Powder: | √ |
| Enamel Powder: | × |
|
|
| Error/cause | Troubleshooting |
| Injector nozzle, non-return valve unit, powder hose or powder gun are clogged |
Clean the corresponding parts and if necessary,replace them |
| Conveying vacuum too low | Increase the powder quantity and/ or total air volume on the control unit |
| Insert sleeve worn , not or incorrect inserted |
Replace or insert it ,observe the indexing cam |
| Insert sleeve is worm after a short operating duration |
Clean the nozzle ,if damaged,replaced it |
| The gun does not spray powder although the control unit is switched on and the gun trigger is pressed |
1.Connect the machine to the compressed air 2.Clean /Replace 3.Clean the corresponding 4.Contact Galin representative |
){kind=link}