| Customization: | Available |
|---|---|
| Warranty: | 12months |
| Type Machine: | Manual Powder Coating |
| Shipping Cost: | Contact the supplier about freight and estimated delivery time. |
|---|
| Payment Methods: |
|
|---|---|
| Support payments in USD |
| Secure payments: | Every payment you make on Made-in-China.com is protected by the platform. |
|---|
| Refund policy: | Claim a refund if your order doesn't ship, is missing, or arrives with product issues. |
|---|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
| GALIN POWDER COATING MACHINE (ESP101) ELECTRICAL DATA | |
| Nominal input voltage | 220V (100V-240VAC) |
| Frequency | 50/60 Hz |
| Input power | 50 VA |
| Rated output voltage | 12~18VPP |
| Rated output current | 1.2A |
| Protection type | IP54 |
| Temperature rang | +10ºC to +40ºC (+50ºF to +104ºF) |
| Solenoid Valve Voltage | 24VDC |
| Gun output voltage | 0-100KVDC |
| Gun output current | 0-100μA |
| GALIN POWDER COATING MACHINE (ESP101) PNEUMATICAL DATA | |
| MAX.Input pressure | 8bar |
| MIN.Input pressure | 5bar |
| Output pressure | 0~8bar |
| Max.Water vapor content of the compressed air | 1.3g/m³ |
| Max.Oil vapor content of the compressed air | 0.1mg/m³ |
| Max.Compressed air consumption | 19Nm³/h |
| GALIN POWDER COATING MACHINE (ESP101) GUN PARAMETER | |
| All the guns in the pictures match the Galin ESP101 | |
| Input | 12~18VPP |
| Voltage Frequency | Around 25KHZ |
| Input Current | 1.2A |
| Output Voltage | 0~100KV DC |
| Max.Output powder volume | Around 600G/MIN |
| Gun cable | 4 M |
| Gun weight | 490g |
| Error/cause | Troubleshooting |
| Injector nozzle, non-return valve unit, powder hose or Powder gun are clogged |
Clean the corresponding parts and if necessary,replace them |
| Conveying vacuum too low | Increase the powder quantity and/ or total air volume on the control unit |
| Insert sleeve worn , Not or incorrect inserted |
Replace or insert it ,observe the indexing cam |
| Insert sleeve is worm after A short operating duration |
Clean the nozzle ,if damaged,replaced it |
| The gun does not spray powder although the control unit Is switched on and the Gun trigger is pressed |
1.Connect the equipment to the compressed air 2.Clean /Replace 3.Clean the corresponding 4.Contact Galin representative |
){kind=link}