Galin Coating/spray/paint mother board/
printed circuit board/PCB (DDCC)
It is suitable for Galin powder coating machine
GALIN POWDER COATING PCB OF MACHINE (DDCC) ELECTRICAL DATA |
Nominal input voltage |
220V (100V-240VAC) |
Frequency |
50/60 Hz |
Protection type |
IP54 |
Temperature rang |
+10ºC to +40ºC (+50ºF to +104ºF) |
ADVANTAGE OF POWDER COATING PCB (DDCC) OF MACHINE |
Voltage and current can be adjusted separately
Three modes:Flat/Corner/Re-coat
Suitable for groove,corner
Powder charge rate:65%~85%
APPLICATION AREA OF POWDER COATING MACHIEN |
Galin powder coating machine can be used for Hub
Galin powder coating machine can be used for Furnitur
Galin powder coating machine can be used for Metal Rail
Galin powder coating machine can be used for Metal products
Galin powder coating machine can be used for Glass products
Galin powder coating machine can be used for Metal or Glass Cup
Galin powder coating machine can be used for Any Metal or Glass you want
Galin Manual powder coating machine (TCL-3) can be used for Grooves and Corners
Galin Manual powder coating machine (TCL-3) can be used for Complex and Difficult Workpiece
ATTENTIONS OF POWDER COATING MACHINE |
CLEANING AND MAINTENANCE
Daily Maintenance
1. Clean the injector
2. Clean the powder gun
3. Clean the powder hose and suction unit
Weekly Maintenance
1. Clean suction unit,injector,Powder Clean module and powder gun
2. Check the control unit grounding connections to the coating booth bolts,
the suspension devices of the work pieces,or the conveyor.
TROUBLESHOOTING GUIDE
If the powder gun does not spray powder although the control unit is switched on,then the injector can be dirty or clogged.
Error/cause |
Troubleshooting |
Injector nozzle, non-return valve unit, powder hose or powder gun are clogged |
Clean the corresponding parts and if necessary,replace them |
Conveying vacuum too low |
Increase the powder quantity and/ or total air volume on the control unit |
Insert sleeve worn , not or incorrect inserted |
Replace or insert it ,observe the indexing cam |
Insert sleeve is worm after a short operating duration |
Clean the nozzle ,if damaged,replaced it |
The gun does not spray powder although the control unit is switched on and the gun trigger is pressed |
1.Connect the equipment to the compressed air 2.Clean /Replace 3.Clean the corresponding 4.Contact Galin representative |
COMPANY INFORMATION OF GALIN |