After-sales Service: | Online |
---|---|
Warranty: | Online |
Type: | Electrostatic Spraying Equipment |
Samples: |
---|
Customization: |
---|
Shipping Cost:
Estimated freight per unit. |
about shipping cost and estimated delivery time. |
---|
Payment Method: | |
---|---|
Initial Payment Full Payment |
Currency: | US$ |
---|
Return&refunds: | You can apply for a refund up to 30 days after receipt of the products. |
---|
Suppliers with verified business licenses
Galin/Gemaa Metal/Plastic Powder Coating/Spray/Paint Equipment (OPTFlex-2F) |
GALIN POWDER COATING EQUIPMENT (OPTFlex-2F) ELECTRICAL DATA |
|
Nominal input voltage | 110V240VAC |
Frequency | 50-60Hz |
Connected load (without vibrator) | 140 VA |
Nominal output voltage (to the gun) | eff.10 V |
Nominal output current (to the gun) | max. 1.2 A |
Connection and output for vibrator (on Aux output) | 110/230 VAC max. 100 W |
Connection for rinsing function (valve) | 24 VDC max. 3 W |
Temperature range | 0°C - +40°(+32°F - +104°F) |
Max. surface temperature | 120 °C (+248 °F) |
Approvals | II 3 D IP54 120 °C |
GALIN POWDER COATING EQUIPMENT (OPTFlex-2F) PNEUMATICAL DATA |
|
MAX.input pressure | 10bar |
MIN.input pressure | 6bar |
Input pressure (Dynamic based on pressure regulator setting) |
5.5 bar / 80 psi |
Max.water vapor content of the compressed air | 1.3g/Nm³ |
Max.oil vapor content of the compressed air | 0.1mg/Nm³ |
Max.compressed air consumption | 8Nm³/h |
GALIN POWDER COATING EQUIPMENT (OPTFlex-2F) PROCESSIBLE POWDER |
|
Plastic Powder: | √ |
Metallic Powder: | √ |
Enamel Powder: | × |
Error/cause | Troubleshooting |
Injector nozzle, non-return valve unit, powder hose or powder gun are clogged |
Clean the corresponding parts and if necessary,replace them |
Conveying vacuum too low | Increase the powder quantity and/ or total air volume on the control unit |
Insert sleeve worn , not or incorrect inserted |
Replace or insert it ,observe the indexing cam |
Insert sleeve is worm after a short operating duration |
Clean the nozzle ,if damaged,replaced it |
The gun does not spray powder although the control unit is switched on and the gun trigger is pressed |
1.Connect the equipment to the compressed air 2.Clean /Replace 3.Clean the corresponding 4.Contact Galin representative |
Suppliers with verified business licenses